Change the network interface used for the Cloud Extension
From the connector Network page you choose which interfaces the Cloud Extension uses, without changing the network card facing the Internet.
The Cloud Extension can use one or more of the connector’s network cards, and you choose which ones. You make the choice on the Network page of the connector web interface, in the SISTEMA section of the menu.
The two cards on the page
At the top is the Internet Interface (eth0) card, for the network card the connector uses to reach Sefthy. Here you choose the Address Type between DHCP and Static IP. If you are working on the Cloud Extension, leave this card unchanged.
Below it is the Cloud Extension Interface card, the one you work on in this procedure.
Changing the interfaces
- Open Network from the connector menu.
- In the Cloud Extension Interface card, under Available Interfaces, tick the network cards you want to use and untick the ones you do not need. You can select more than one.
- Check the Current Configuration section just below, which lists the interfaces already in use with their Up or Down status.
- Click Apply Configuration.
The message “Please wait, applying configuration…” appears while the connector applies the new network configuration. The page may not respond for a few seconds, then it becomes available again automatically.
If you try to save with no interface selected, the connector rejects the configuration and asks you to select at least one network interface.